Please be aware that we cannot be held responsible for any failing due to the structural design of your model. Take a moment to read through our the information below and then e-mail or call us for a quote.

Email thinglab@inition.co.uk / Tel +44 (0)20 7613 5004

Remember to make the most of the 3D printer’s capabilities – sub-millimetre detail, accurate surface finish; even moving parts are possible. Just remember to make sure your design will work in the real world, for example:

Will the model be able to support its own weight?

Make sure all parts of the model connect - otherwise your print will fall apart!

Think about the strength of small cross sections

Allow a small tolerance if you are designing moving or tight fitting parts

Try and avoid holes and intersections in the mesh

Remember, very small details cannot be guaranteed to reproduce correctly

Max volume of single 3d print 298 x 185 x 203mm

Hollow out large volumes to save material and therefore money...